We service all of New Hampshire (NH) , Massachusetts (MA) , and Maine (ME) with Decorative Concrete, Stamped Concrete, Epoxy Floor Coatings, and Garage Flooring. We have a large selection of colors and patterns! Give us a call for your next concrete project. We provide Free Estimates.
Can Stamped Concrete Be Power Washed?
Yes, stamped concrete can be power washed with a pressure washer and use the proper concrete cleaning agents for maximum cleaning efficiency while pressure washing is the best procedure. Be sure to use the correct nozzle tip and water pressure for the job. Start by spraying the surface with water to loosen any dirt or debris. Then, point the nozzle tip of the pressure washer at a 45-degree angle and start washing. Move the nozzle back and forth across the surface, being careful not to damage the stamped surface. Rinse with clean water when finished.
Here’s How To Power Wash Your Decorative Concrete
If you want to power wash your stamp concrete, you’ll need to use a pressure washer with a fan tip nozzle. Point the nozzle at a 45-degree angle and spray the surface with a concrete cleaning detergent. Be sure to keep the nozzle moving so that you don’t damage the surface and keep the nozzle at least 12 inches away from the surface. Let the detergent sit for a few minutes before washing it off, then rinse it off thoroughly with clean water.
Detailed Steps Below:
1. Set up your pressure washer and fill the detergent tank with the concrete power wash cleaning agent.
2. Connect the fan tip nozzle to the end of your pressure washer wand.
3. Start the pressure washer.
4. Begin washing the concrete with a sweeping motion, holding the nozzle at least 12 inches away from the surface.
5. Work in small sections and overlap your strokes.
6. Rinse the concrete with clear water as you go.
7. Repeat steps 4-6 until the entire surface is washed.
8. Allow the concrete to air dry before applying a sealer.
What Cleaning Agent Should I Use With Pressure Wash
When it comes to concrete cleaning agents, there are many types and methods to choose from. A variety of factors must be considered when selecting the best agent for the job, such as the type of concrete, its age and condition, and the specific type of stain or dirt that needs to be removed. For decorative concrete, a degreaser or alkaline-based cleaner is often recommended.
Some degreasers are made specifically for concrete and work well on both oil and grease stains. Others are designed for general use around the house and can be effective on light oil or grease stains. In either case, always test the cleaner in an inconspicuous area before using it on the entire surface. Be sure to follow all safety instructions when using any cleaning agent.
Alkaline-based cleaners are also effective at removing dirt and grime from concrete.
3 Best Cleaning Agents & Stain Removers For Concrete
Maximum Power: Zep – Industrial Purple Degreaser
Medium Power: Zep – Driveway and concrete pressure wash concentrate
Mild Power: Simple Green – Concrete and driveway outdoor cleaner pressure washer
Depending on how dirty your concrete surface is, we recommend Zep Industrial Purple Degreaser.
We use it on all our textured colored concrete cleaning and sealing projects. It takes the toughest stains out easily, while not doing any damage to the colored concrete surfaces. Just follow the manufacturer’s recommendations on the back of the bottle or container.
Power Washing Keeps Stamped Concrete Looking Crisp & Clean
If you have a recolored and resealed decorative concrete patio, driveway, or any other surface, power washing is the way to go. It needs to remain looking crisp. Anyone with a bit of experience using a power washer can quickly and easily do it.
To start, you’ll want to make sure that the surface is clean and free of any debris or dirt. Once it’s ready, wet the surface down with water and begin spraying it with the power washer. Start from the top and work your way down, being sure to get all of the nooks and crannies.
You’ll want to keep the pressure on the high side as you wash, but be careful not to damage the surface. If you’re not sure how much pressure is too much, start on the lower end and work your way up.
What Type of Pressure Washer Should I Use to Clean Concrete?
When it comes time to clean your stamp concrete, you will want to use a pressure washer. However, not all pressure washers are created equal. There are three types of pressure washers that you can choose electric, gas, and diesel.
Electric pressure washers are the most popular type. They are affordable and easy to use. They are also lightweight and perfect for small jobs. However, they don’t have a lot of power so they aren’t ideal for large projects.
Gas pressure washers are more powerful than electric pressure washers. They can be used for larger projects. However, they are heavier and require more maintenance.
Diesel pressure washers are the most powerful type of pressure washer. They can be used for the largest projects. However, they are also the heaviest and require the most maintenance.
Any type of pressure washer will work. Gas pressure washers work most efficiently when cleaning decorative concrete surfaces.
Power Washing Tips For Colored Concrete
1. If you have a concrete driveway, patio, or walkway, power washing it every year is a good way to keep it looking its best.
2. To power wash concrete, you’ll need a garden hose, a power washer, and some detergent.
3. Start by spraying the concrete with water to wet it down. This will help the detergent to penetrate the surface of the concrete.
4. Add detergent to your power washer and begin spraying the concrete. Be sure to cover all surfaces evenly.
5. Let the detergent sit on the concrete for a few minutes before rinsing it off with water from your hose.
6. Be sure to rinse off all of the detergents completely or it may cause staining.
Recommendations: Seal Your Stamp Surface After Cleaning
Concrete that is stamped is a beautiful addition to any home, but it’s important to keep it clean and sealed properly to protect it from the elements.
1. Sealing your stamped concrete is also easy – just apply a sealant of your choice to the surface and let it dry.
2. Be sure to read the instructions on the sealant carefully, as each one requires different application methods.
3. Applying sealant every 3 to 5 years will help protect your stamped concrete from fading, staining, and weathering.
4. Make sure you add a slip-resistance additive to the concrete sealer.
In conclusion, stamped concrete can be power washed but it is important to take into account the type of stamp used, the color of the concrete, and the sealant used. If power washing is not done correctly, it can damage the stamp concrete. It is best to consult with a professional before power washing decorative concrete.
- Is Stamped Concrete Worth The Money
- Whats Cheaper Stamped Concrete or Pavers
- How Long Does Stamped Concrete Last
- Is Stamped Concrete Slippery
- How Thick Should Stamped Concrete be
- How Is Stamped Concrete Installed
- Is Stamped Concrete Durable
Our Locations:
Nashua, NH
North Hampton, NH
Concord, NH